Under system firmware customization custom commands post session is there a document with custom post session commands available? Currently that is where I have Horizon with the command logoff to logoff the session. I can look, and I will let you know if I find anything, but I don’t think we do It would have to be in the Horizon Client configuraiton, and I don’t think we have access to it OK I was hoping there was a timeout configuration
May need to open a case with VMWare and IGEL and pull the Horizon Client logs to see if either side can determine what is happening with that connection. Those all should be supported and I don’t see any discrepancies. OK, just wanted to make sure things line up. Sorry, I meant the version of your Horizon environment, not the client on the IGEL device. From what I can see it is connected long enough to start the Horizon VM session because when you log back in the session is logged in.Ĭan you tell me what version of the firmware and what version of Horizon you are running?Īlso, are you using BLAST, PCoIP, or RDP?įirmware 11.0.1.130.01 the version of Horizon presented in that version of the firmware is 5.0.0 build 12557422 using PCoIP Good morning are you saying that the Horizon session occasionally fails to connect, or immediately disconnects after connecting to a Horizon desktop? Is there a setting or another configuration I can make to help prevent the Horizon Client session from disconnecting causing the system to logoff with my policy?
In windows there is a registry setting for the timeout. I am running in to an occasional issue when the horizon client session starts it disconnects then logs out the session. Horizon Client session set to auto logoff system session when ended : I was able to setup a profile that auto logs off my system when Horizon client session ends.